Configuring The Fpga - Xilinx Virtex-7 FPGA VC7222 IBERT Getting Started Manual

Figure 1-8
GTH IBERT demonstration.
X-Ref Target - Figure 1-8
Figure 1-8: Cable Connections for Quad 115 GTH IBERT Demonstration

Configuring the FPGA

This section describes how to configure the FPGA using the SD card included with the
board. The FPGA can also be configured through Vivado Design Suite using the .bit files
available on the SD card, or online (as collection
rdf0297-vc7222-ibert-2014-2.zip) at the
Kit documentation
To configure the FPGA using the SD card:
1.
2.
VC7222 IBERT Getting Started Guide
UG971 (v5.0) June 12, 2014
shows the VC7222 board with the cable connections required for the Quad 115
website.
Insert the SD card provided with the VC7222 board into the SD card reader slot located
on the bottom-side (upper-right corner) of the VC7222 board.
Plug the 12V output from the power adapter into connector J2 on the VC7222 board.
www.xilinx.com
Running the GTH IBERT Demonstration
Virtex-7 FPGA VC7222 Characterization
Send Feedback
13