ResMed H5i User Manual page 6

Getting started
1. Make sure your S9 and H5i are connected and the water tub is filled to the maximum water level
mark.
2. Adjust the humidification level if required.
3. Fit your mask as described in your mask user guide.
4. To start therapy press .
5. Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
6. To stop treatment at any time or press .
Note: Once therapy has started a treatment screen is displayed.
Disassembling the H5i
Refer to illustration E.
1. Slide the latch.
2. Lift open the flip lid.
3. Remove the water tub.
4. Discard any excess water from the water tub.
5. Unclip all four side latches.
6. Pull apart the tub lid, plate and base.
Reprocessing the H5i and air tubing between patients
The H5i and air tubing should be reprocessed when used between patients. Cleaning and disinfection
instructions are available from the ResMed website, www.resmed.com under Products and Service &
Support. If you do not have internet access, please contact your ResMed representative.
Reassembling the H5i
1. Place the plate back onto the base ensuring that the maximum water level mark faces up.
2. Place the tub lid back onto the plate/base ensuring that the centre holes are aligned.
3. Clip all four side latches.
4. Fill the water tub and return the water tub to the H5i.
5. Close the flip lid ensuring that it clicks into place.
4