Download Print this page

ResMed H5i User Manual page 4

Heated humidifier for s9 vpap tx
Hide thumbs Also See for H5i:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Do not use any additives (eg, scented oils and perfumes). These may reduce the humidification
output of the H5i and/or cause deterioration of the water tub materials.
Take care when handling the H5i as the water/water tub may be hot. Allow 10 minutes for the
heater plate and any excess water to cool.
The H5i should only be connected or disconnected when the water tub is empty.
Make sure that the water tub is empty before transporting the H5i.
Do not operate the H5i on an aircraft as water may enter the device and air tubing during
turbulence.
Always place the H5i on a level surface below the level of the user to prevent the mask and tubing
from filling with water.
If liquids are inadvertently spilled into or on the H5i, unplug the device from the power outlet.
Disconnect the H5i from the device and allow it to drain and dry before re-using.
H5i indications for use
The H5i is indicated for the humidification of the air delivered from a CPAP or bilevel device. The H5i is
for use only as recommended by a physician. The H5i is intended for single patient re-use in the home
environment and re-use in a hospital/institutional environment.
Contraindications
The H5i is contraindicated for use with patients whose upper (supraglottic) airway has been bypassed.
Please refer to the S9 VPAP Tx Clinical Guide for contraindications associated with CPAP or bilevel
therapy.
Setup
Refer to illustration A.
1. Align your H5i with your S9 and push them together until they click into place.
2. Connect the DC plug of the power supply unit to the rear of the S9.
3. Connect the power cord to the power supply unit.
4. Plug the other end of the power cord into the power outlet.
5. Connect one end of the air tubing firmly onto the air outlet.
6. Connect the assembled mask system to the free end of the air tubing.
Filling the water tub
Refer to illustration B.
1. Slide the latch and lift open the flip lid.
2. Remove the water tub.
3. Fill the water tub (through the centre hole) with distilled or deionized water up to the maximum
2

Advertisement

loading