Smeg Oven SCA112XP2 Instruction Manual page 37

Instructions for the user
10.5 What to do if.
The oven display is full
off
The oven does not
heat up
The controls do not
respond.
The cooking times are
longer than those
indicated in the table.
After the automatic
"pyrolysis" cleaning
cycle (only on some
models) it is not
possible to select a
function.
The display shows
ERR 4
(on pyrolytic models
only)
If the door is opened
during a ventilated
function, the fans
stops.
If the problem has not been resolved or for other types of faults, contact
your local technical assistance centre.
• Check the mains power supply.
• Check whether
upstream from the oven feed line is in the
"ON" position.
• Check whether the "showroom" mode has
been set, for further details see paragraph
"Secondary menu" at page 20.
• Check whether the "child lock-out function"
mode has been set, for further details see
paragraph "Secondary menu" at page 20.
• Check whether the "2300 W" mode has been
set, for further details see paragraph
"Secondary menu" at page 20.
• Verify whether the interlock device has
switched off. If it has not, the oven has a
protection device that does not allow
functions to be selected while the interlock
device is active. This is because the
temperatures inside the oven are still too
high to permit any type of cooking.
• The interlock device has not hooked up to
the door properly. These might be because
the door was accidentally opened during its
activation. Switch off the oven and switch it
on again waiting a few minutes before
selecting a new cleaning cycle.
• This is not a fault. It is a normal operation of
the appliance, useful for when cooking foods
to avoid excessive heat escaping. When the
door is closed, the oven will return to normal
operation.
an omnipolar switch
39