Secondary Menu - Smeg Oven SC110 Instruction Manual

Instructions for the User
Modifying the data set
Once automatic cooking has started, its duration can be changed.
When the and
the oven is in standby status waiting for cooking to start, press PT1 once.
The symbol starts flashing and PT1 can be turned to change the set
duration.
Press PT1 again; the
flash, and the cooking start time will be displayed on DSP1. The cooking
start time can be increased or decreased by turning PT1.
A few seconds after the last change, the
steady mode) on DSP1 and automatic cooking will restart with the new
settings.
Once cooking has been programmed, before it starts all the lamps on the
control panel will be on, except for DSP2 which will illuminate when
cooking has started, showing the set temperature.
7.6

Secondary menu

This appliance also has a concealed "secondary menu" allowing the user
to:
1 Activate or deactivate the child safety device (
2 Activate or deactivate the Show Room function (which disables all the
heating elements so that only the control panel works);
3 Activate or deactivate the function which limits the maximum power
absorption to 2300 W;
7.6.1 Child safety lock-out function
With the oven in OFF status (see point "7.2 Operating modes") keep PT1
pressed until the message OFF SHO appears on DSP1. Now press PT1
until the message "OFF BLOC" appears on DPS1.
Turn PT1 to the right or left to activate (ON BLOC) or deactivate (OFF
BLOC) this function, which locks out all the functions and knobs after 3
minutes of operation without any command from the user (when this
system is active, the
After setting the parameter required, press PT2 to return the oven to the
initial standby status.
To exit the lockout status temporarily to modify a cooking program or
select a different function, keep PT1 pressed until the
disappears from DSP2. The required changes can now be made, and 3
minutes after the last setting is made the lockout will come into operation
again.
To deactivate the lockout permanently, access the secondary menu and
switch the function off as described in this section.
symbols are steady and cooking is in progress, or
symbol goes out, the
symbol appears on DPS2).
symbol will start to
e symbols will appear (in
);
symbol
43