Table of Contents
Advertisement
Setting Up
the Gateway
The instructions that follow parallel the steps contained in the Actiontec Installation
™
Buddy
, which provides a visual guide to setting up the Gateway. It is recommended
the user run the Installation Buddy first, before attempting any other procedures.
To set up the Gateway, it must be connected to a computer, and then configured.
After connecting this first computer, other computers can be added to the network
via
or Ethernet (see "Setting Up a Network" on page 65).
USB
Connecting a Computer to the Gateway
Connecting a computer to the Gateway for setup involves three basic steps: initial
setup, plugging in the Gateway's power cord, and connecting the Gateway to the
computer.
Connecting Via Ethernet
1. Insert the Installation
Installation Buddy starts automatically. Wait until the following screen
appears, read the on-screen instructions, then click Next.
in the
CD
CD-ROM
7
drive of the computer. The
2
Advertisement
Table of Contents
