Table of Contents
Advertisement
Installation
Important Note: Please do not connect any USB devices to
the Hub until instructed to do so in step 4 of this installation
procedure.
1. Plug the AC adapter into a wall outlet or surge protector.
Plug the DC connector into the DC power jack found on
the rear of the Hub.
2. Plug the flat end of the provided USB device cable into
the downstream port of your computer, or downstream
port of another hub, and then plug the mini-USB
connector of the device cable into the upstream port on
the rear of the Hub.
Important Note: The Hub must be connected to a USB
2.0-compliant host in order to function in high-speed
mode (480Mbps data rate). If the Hub is connected to a
USB 1.1-compliant host, it will operate only in low-speed
or full-speed mode (1.5Mbps/12Mbps).
4
1
2
3
Hide quick links:
Advertisement
Table of Contents
