Sagem COSY Phone Manual page 68

Table of Contents

Advertisement

independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phones employs a
unit of measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC and Health Canada is
0.979 W/kg (*). Tests for SAR are conducted using standard
operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the
highest certified power level, the actual SAR level of the
phone while operating can be well below the maximum
value. This is because the phone is designed to operate at
multiple power levels so as to use only the power required to
reach the network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
Before a phone model is available for sale to the public, it
must be tested and certified to the FCC that it does not
exceed the RF limit established by the government-adopted
requirement for safe exposure. The tests are performed in
positions and locations (i.e., at the ear and worn on the
body) as required by the FCC for each model.
The highest SAR value for these model phones as reported to
the FCC when tested for use at the ear and when worn on
the body are (measured at a distance of 0.59 inches (1.5
cm)):
(*) In the United States and Canada, the SAR limit for mobile
phones used by the public is 1.6 watts/kilogram (W/kg)
averaged over one gram of tissue. The standard
incorporates a substantial margin of safety to give
additional protection for the public and to account for
any variations in measurements.
68Certification and safety information for the united states and countries

Advertisement

Table of Contents
loading

Table of Contents