Connection Of An Encoder To The Fm 351 Positioning Function Module - Siemens SIMATIC FM 351 Installation Manual

Wiring the FM 351
Connecting the
Encoders
4
Procedure
4-8
The connection of an encoder to the FM 351 Positioning Function Module is
shown in Figure 4-5.
Figure 4-5 Connection of an Encoder to the FM 351 Positioning Function Module
Proceed as follows to connect the encoders:
1. Connect the connecting cable to the encoder.
With absolute encoders it may be necessary to assemble the cable (cable-
end at the encoder) according to the manufacturer's specification.
2. Open the front door and plug the subminiature Cannon connector to the
FM 351 Positioning Function Module.
3. Lock the connector with the aid of the knurled screws. Close the front
door.
4. Remove the insulating material on the connecting cable and clamp the
cable shield in the shield supporting element. To do this, use the shield
terminal.
FM 351 Positioning Function Module
EWA 4NEB 720 6001-02