Cable Connection To The Wireless Communication Module - Siemens SITRANS FM MAG 8000 IIoT Operating Instructions Manual

Connecting

5.3 Cable connection to the Wireless Communication Module

7. Push rubber tubing into M20 cable gland. Adjust antenna cable and analog inputs cable
making sure that the shield of the analog inputs cable and the SMA connector are fixed by the
cable clamp kit. Tighten the two screws of the cable gland kit.
8. Mount the M20 cable gland cover. Tighten it to torque 10 Nm.
5.3 Cable connection to the Wireless Communication Module
Note
Shielding
One end of each cable must have its shield connected to protective earth. If a connector is used
at this end, the shell of the connector must be connected to the shield of the cable.
26
SITRANS FM MAG 8000 IIoT Wireless Communication Module
Operating Instructions, 07/2022, A5E52070595A-AA