Belkin OmniCube P72462 User Manual page 10

Usage
Selecting which computer to operate can be done either by pressing the
SELECT button, or through keyboard hot-key commands. You will notice that
after the OmniCube™ switches to another computer, the mouse will be
inoperative for about 1-2 seconds. This is normal operation and ensures that
proper mouse synchronization is established.
Pressing the SELECT button cycles
you through ports 1 - 4.
Keyboard Hot-Key commands:
To send commands to the OmniCube
pressed twice within 2 seconds. You will hear a beep for confirmation. Below
are the different commands:
Scroll
Lock
Scroll
Lock
Scroll
Lock
Scroll
Lock
In AutoScan mode, the OmniCube
switching to the next. There is no mouse or keyboard control in this mode.
This is necessary to prevent errors. Otherwise, if the user is moving the mouse
or using the keyboard when the OmniCube
flow is interrupted and will cause erratic mouse movement and/or the wrong
characters to show up when using the keyboard.
To get out of AutoScan mode, hit the SPACEBAR.
Scroll
1
Lock : Switch to Port 1
Scroll
3 : Switch to Port 3
Lock
Scroll
: Switch to previous port
Lock
Scroll
: Enables AutoScan mode.
Lock 0
OmniCube
CONSOLE
™ , the SCROLL LOCK key must be
Scroll Scroll
Lock Lock 2
Scroll Scroll
Lock Lock 4
Scroll Scroll
Lock Lock
remains on one port for 10 seconds before
™
switches to the next port, data
™
10
™
4-Port
1 2 3 4 Select
F1D094
: Switch to Port 2
: Switch to Port 4
: Switch to next port