Belkin OmniCube User Manual page 13

P73050/F1D092AM/man.qxd
Selecting which computer to operate can be done either by pressing the
SELECT button, or through keyboard "Hot" key commands. You will notice
that after the OmniCube
inoperative for about 1-2 seconds. This is normal operation and ensures that
proper mouse synchronization is established.
Pressing the SELECT button cycles
you through ports 1 and 2.
Keyboard "Hot" Key commands:
To send commands to the OmniCube
pressed twice within 2 seconds. You will hear a beep for confirmation.
Below are the different commands:
In AutoScan mode, the OmniCube
before switching to the next. There is no mouse or keyboard control in this
mode. This is necessary to prevent errors. Otherwise, if the user is moving
the mouse or using the keyboard when the OmniCube
port, data flow is interrupted and will cause erratic mouse movement and/or
the wrong characters to show up when using the keyboard.
To get out of AutoScan mode, press the SPACEBAR.
4/28/00 1:43 PM
Usage
switches to another computer, the mouse will be
™
, the SCROLL LOCK key must be
™
: Switch to Port 1
: Switch to
previous port
: Enables AutoScan mode
remains on one port for 10 seconds
™
9
Page 9
: Switch to Port 2
: Switch to
next port
™ switches to the next
En