Advertisement
P74386ea_F5U234ea_uk 08-09-2003 11:13 Page 4
Important Note: Please do not connect any USB devices to the Hub until
1. Plug the AC adapter into a wall outlet, or surge suppressor. Plug the
DC connector into the DC Power Jack found on the side of the Hub.
Important Note: The Hub may be used without the power supply when
2. Plug the flat end of the provided USB device cable into the
downstream port of your computer or downstream port of another
hub, then plug the mini 6-pin connector of the device cable into the
upstream port on the rear of the Hub.
Important Note: The Hub must be connected to a USB 2.0-compliant host
3. Windows will now detect your Hub and install the required driver
support. (The Windows "Install New Hardware Wizard" may prompt
you to provide your Windows Installation CD to complete the driver
installation process).
INSTALLATION
instructed to do so in step 4 of this installation
procedure.
connecting devices that draw 100mA of current or less,
however, only port 1 and port 2 will be functional.
in order to function in high-speed mode (480Mbps data
rate). If the Hub is connected to a USB 1.1-compliant
host, it will operate only in low-speed or full-speed mode
(1.5Mbps/12Mbps).
4
Advertisement
