Table of Contents
Advertisement
GUI Overview
When an input to the GUI is changed, the GUI should send this new value to the device automatically
once the cursor has clicked on another field besides the field being changed. It is good practice, however,
to reload all registers once changes to inputs have been made. This can be achieved by clicking on the
"OFF" button below "Load All" in the bottom right corner of the GUI (see
If there is ever a doubt as to the integrity of the communications between the GUI and the device, a USB
reset is in order. Press the Reset USB button near the top left corner of the GUI and then reload all
registers again (see
An explanation of all the fields within the Quick-set tab is provided by device functionality beginning with
the synthesizers.
2.1
GUI for Synthesizers
The TX and RX synthesizers are controlled using the group of dialog boxes under "Quick-Synth" (see
Figure
14).
12
List of Tables
Figure 12. Load All Registers
Figure
13).
Figure 13. Reset USB
Figure 14. Synthesizer Programming
www.ti.com
Figure
12).
SLWU065 – September 2009
Submit Documentation Feedback
Advertisement
Table of Contents
