Mounting And Installation - Siemens SICLOCK PCON Operating Instructions Manual

Mounting and installation

The SICLOCK PCON is mounted on a 35mm DIN rail. The power supply is con-
nected to terminals 14 and 15 of the terminal strip X1, and must generally be con-
nected by a separate cable. The electrical inputs are also found on terminal strip
X1. All electrical outputs are found on terminal strip X2. In general, signal lines
should always be twisted and shielded control lines. The shield should be con-
nected to the equipotential bonding terminal of the electronics cabinet.
Fig. 3-1
®
SICLOCK PCON
Operating Instructions, 04/2012, A2B00056366E-01
Front plate with terminal marking
3
3-8