• Rear transmission cradle pivots (A, Figure 16).
• Front caster wheel axles (A, Figure 18).
Use grease fitting when present. Disassemble parts to apply
grease to moving parts when grease fittings are not installed.
Not all greases are compatible. Red grease (p/n 5022285)
is recommended, automotive-type high-temperature, lithium
grease may be used when this is not available.
Oil:
• Discharge chute pivots (B, Figure 15).
• Ground speed control lever and neutral linkage rod pivots
(A, Figure 17).
• Seat plate pivots (B, Figure 16).
• Deck lift linkage pivots (C, Figure 16).
Generally, all moving metal parts should be oil where contact
is made with other parts.
Keep oil and grease off of belts and pulleys. Remember to
wipe grease fittings and surfaces clean both before and after
lubrication.
15
16
17
9