Quick Guide; Basic System Configuration; Installing An Optional Card - Yamaha RIVAGE PM7 Systems Setup Manual

Quick Guide

This section describes the basic setup procedure for the
RIVAGE PM7 system.

Basic system configuration

I/O Network
The setup procedure is explained using a system
comprised of the following devices:
• Digital mixing console (CSD-R7) ×1
• I/O rack (RPio622) ×1
• HY card (HY256-TL) ×2
• RY card (RY16-ML-SILK) ×1
• RY card (RY16-DA) ×1
Procedure

Installing an optional card

Setting the Unit ID
Connecting the devices
Turning on the power to the RIVAGE PM7 system
Setting the word clock
Assigning channels to the TWINLANe network
Patching the input ports
Patching the output ports
Setting the analog gain for HA (Head Amp)
Sending an input channel signal to the STEREO bus
Installing an optional card
HY card installation
Install a TWINLANe network card into HY card slot 1 on
both the digital mixing console and I/O rack. HY card slot
1 is used exclusively for a TWINLANe network card.
RY card installation
Install an RY16-ML-SILK mic/line input card into RY card
slot 1 on the I/O rack.
Install an RY16-DA analog output card into RY card slot 2
on the I/O rack.
Installing an RY card
1.
Make sure that both power indicators are off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Remove the screws that fasten the slot cover
to remove the slot cover.
Keep the cover and fixing screws in a safe place for
future use.
RIVAGE PM7 System Setup Guide
Slot cover
35