Advertisement
Instructions for the installer
2. INSTALLATION OF THE APPLIANCE
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are heat
resistant (T 90°C).
2.1 Fixing the conventional built-in model to the structure
(fig. 1)
Create an opening with the
dimensions shown in the figure
in
the
top
surface
counter, keeping a minimum
distance of 50 mm from the
rear border.
This appliance is classified as
"type Y" in relation to fire
hazards and can therefore be
mounted against walls higher
than the work surface on
condition that a certain distance "X" be kept between the appliance and
the wall as shown in the figure so as to avoid damage from overheating.
Make sure there is a minimum of 750 mm between the hot plate flames
and any shelf that may be installed directly above them.
Accurately position the gasket provided all around the outer edge of the
hole in the top surface as shown in the figures below, pressing it down
so as to make it adhere properly. For measurements, refer to the figure
depending on the hob model to be installed, bearing in mind that in both
models the front and rear sides must skim the hole. Secure the hob to
the counter with brackets A or B(supplied). Carefully trim any excess
from border C of the gasket. The distances in the following drawing refer
to the hole on the inner side of the gasket.
Bracket 'A' in the 1st slot
of
the
1
Bracket 'A' in the 2nd slot
19
Advertisement
