Mitsubishi Electric MELSERVO MRJ2S-B Instruction Manual page 99

Parameter
Function
Expansion
parameters
Tab. 4-12: Parameter overview (2)
Set the parameter value and switch power off once, then switch it on again to make that
parameter setting valid.
The values corresponds with the factory settings of the servo amplifier. Connecting it with
the servo system controller and switching power on changes them to the settings of the
servo system controller.
Setting and changing cannot be made from the peripheral software of the motion controller.
MELSERVO J2-Super
No. Symbol Name
27 MO1 Analog output 1 offset
28 MO2 Analog output 2 offset
29 — Reserved
30 ZSP Zero speed
31 ERZ Error excessive alarm level
32 OP5 Function selection 5
33 OP6 Function selection 6
PI-/PID control switch-over position
34 VPI
droop
35 — Reserved
36 VDC Speed differential compensation
37 — Reserved
38 ENR Encoder output pulses
39 — Reserved
40 BLK Parameter entry prohibition
Initial value Unit
0 mV
0 mV
0001 —
50 r/min
80 0.1 × r
0000 —
0000 —
0 Pulse
0 —
980 —
0010 —
4000 Pulse/r
0 —
0000 —
Operation
Customer
setting
4 - 13