Ip Rip Send Version - SMC Networks SMC6724L3 Management Manual

• You can specify the receive version based on these options:
- Use "none" if you do not want to add any dynamic entries to the
routing table for an interface. (For example, you may only want to
allow static routes for a specific interface.)
- Use "1" or "2" if all routers in the local network are based on RIPv1
or RIPv2, respectively.
- Use "1 2" if some routers in the local network are using RIPv2, but
there are still some older routers using RIPv1.
Example
This example sets the interface version for VLAN 1 to receive RIPv1
packets.
Console(config)#interface vlan 1
Console(config-if)#ip rip receive version 1
Console(config-if)#
Related Commands
version (4-235)

ip rip send version

Use this command to specify a RIP version to send on an interface. Use
the no form to restore the default value.
Syntax
ip rip send version {none | 1 | 2 | v2-broadcast}
no ip rip send version
• none - Does not transmit RIP updates.
• 1 - Sends only RIPv1 packets.
• 2 - Sends only RIPv2 packets.
• v2-broadcast - Route information is broadcast to other routers with
RIPv2.
Command Mode
Interface Configuration (VLAN)
IP R C
OUTING OMMANDS
4-237