Snmp-Server Host - SMC Networks SMC6724L3 Management Manual

snmp-server host

Use this command to specify the recipient of a Simple Network
Management Protocol notification operation. Use the no form to remove
the specified host.
Syntax
snmp-server host host-addr community-string
no snmp-server host host-addr
• host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you
define this string using the snmp-server community command
prior to using the snmp-server host command. (Maximum length:
32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server host command, no notifications
are sent. In order to configure the switch to send SNMP notifications,
you must enter at least one snmp-server host command. In order to
enable multiple hosts, you must issue a separate snmp-server host
command for each host.
• The snmp-server host command is used in conjunction with the
snmp-server enable traps command. Use the snmp-server enable
traps command to specify which SNMP notifications are sent globally.
For a host to receive notifications, at least one snmp-server enable
traps command and the snmp-server host command for that host
must be enabled.
SNMP C
OMMANDS
4-93