Lubricate The Front Casters; Servicing The Mower Blades - Ferris SRS Z2 Series Operator's Manual

35

Lubricate the Front Casters

Interval: Annually
1. Remove the 1/4-28 bolt (A, Figure 36) screwed into the
caster and install a 1/4-28 grease fitting.
36
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and reinstall the 1/4-28
bolt.
4. Repeat the process for the other side of the machine.

Servicing the Mower Blades

Removing the Mower Blades
CAUTION
Laceration hazard
Mower blades are sharp.
Always wear gloves when handling, or working near, mower
blades.
1. Use a block of wood to prevent the mower blade from
turning as shown in Figure 37.
37
2. Using a wrench, remove the bolt securing the blade to the
spindle.
Inspecting the Mower Blades
DANGER
Thrown objects hazard
Avoid injury: a worn or damaged mower blade can break and
a piece of the blade could be thrown into the operator's area
or bystander's area resulting in serious personal injury or
death.
• Inspect the mower blade every 25 hours or at least once
per year.
• If the mower blade hits a solid object, stop the engine
immediately and inspect the mower blades.
• Never weld or straighten bent mower blades.
1. Remove the mower blade from the unit. See Removing the
Mower Blades.
2. Inspect the mower blade (Figures 38 and 39). Discard the
mower blade if it has any of the following conditions:
• More than .5" (12,7 mm) of the mower blade metal has
been removed from previous sharpening or wear (A,
Figure 38)
• The air lifts are excessively eroded (A, Figure 39) and
the notch (B) is .25" (6,35 mm) deep or greater.
• The mower blade is broken or bent.
31