SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual page 236

C L
OMMAND INE
Default Setting
Host Address: None
SNMP Version: 1
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server host command, no
notifications are sent. In order to configure the switch to send
SNMP notifications, you must enter at least one snmp-server
host command. In order to enable multiple hosts, you must
issue a separate snmp-server host command for each host.
• The snmp-server host command is used in conjunction with
the snmp-server enable traps command. Use the
snmp-server enable traps command to specify which SNMP
notifications are sent globally. For a host to receive
notifications, at least one snmp-server enable traps
command and the snmp-server host command for that host
must be enabled.
• The switch can send SNMP version 1 or version 2c traps to a
host IP address, depending on the SNMP version that the
management station supports. If the snmp-server host
command does not specify the SNMP version, the default is to
send SNMP version 1 traps.
• Some notification types cannot be controlled with the
snmp-server enable traps command. For example, some
notification types are always enabled.
Example
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands
snmp-server enable traps (3-69)
3-68
I
NTERFACE