NEC N820 Manual page 4

Radio Frequency (RF) Signals(900/1800MHz) Radio Frequency (RF) Signals
THIS NEC PHONE (MODEL N820) COMPLIES WITH THE EU REQUIREMENTS FOR EXPOSURE
TO RADIO WAVES.
Your mobile phone is a radio transceiver, designed and manufactured not to exceed the SAR* limits**
for exposure to radio-frequency (RF) energy, which SAR* value , when tested for compliance against the
standard was (TBD) (TBD)W/kg. While there may be differences between the SAR* levels of various phones
and at various positions, they all meet*** the EU requirements for RF exposure.
*The exposure standard for mobile phones employs a unit of measurement known as the Specific
Absorption Rate, or SAR.
**The SAR limit for mobile phones used by the public is 2.0 watts/kilogram (W/kg) averaged over ten
grams of tissue, recommended by The Council of the European Union. The limit incorporates a
substantial margin of safety to give additional protection for the public and to account for any variations
in measurements.
*** Tests for SAR have been conducted using standard operating positions with the phone transmitting
at its highest certified power level in all tested frequency bands. Although the SAR is determined at the
highest certified power level, the actual SAR level of the phone while operating can be well below the
maximum value. This is because the phone is designed to operate at multiple power levels so as to use
only the power required to reach the network. In general, the closer you are to a base station antenna,
the lower the power output.
Radio Frequency (RF) Signals Radio Frequency (RF) Signals(1900MHz)
THIS NEC PHONE (MODEL N820) COMPLIES WITH THE USA REQUIREMENTS FOR EXPOSURE
TO RADIO WAVES.
Your wireless phone contains a radio transmitter and receiver. Your NEC phone is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U. S. Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific
Absorption Rate (SAR). The SAR limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels so as to use only the power required to
reach the network. In general, the closer you are to a wireless base station antenna, the lower the
output.
Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it
does not exceed the limit established by the government- adopted requirement for safe exposure. The
tests are performed on position and locations (for example, at the ear and worn on the body) as required
by FCC for each model. The highest SAR value for this model phone as reported to the FCC when tested
RF Warning Page
(900/1800MHz)
(1900MHz)
FCC ID# A98-KMP6J1L1 FCC ID# A98-KMP6J1L1
Model # KMP6J1L1-1A Model # KMP6J1L1-1A