Atis Code Programming - Icom IC-M73 Instruction Manual

e Push [Y]/[Z] to select a character.
r Push [CH/WX• U/I/C] to move to the
right; then push [Y]/[Z] to select a
character.
• Pushing [SCAN•DUAL], moves to left
t Continue until the desired charac-
ters have been selected, then push
[H/L•KEY] to return to normal op-
eration.
The programmed opening comment
is briefly displayed or scrolled when
the transceiver is powered ON.
However, the opening comment in-
dication can be skipped by pushing
[16•9].
FUNCTION MODE OPERATION

■ ATIS code programming

The 10-digit ATIS code can be programmed and confirmed
with the following operation.
The ATIS code programming is not necessary and confi
rmation can only be performed when the ATIS code has
been programmed by your dealer. The code programming
can be performed 1 time only, when the code has not
been programmed by your dealer.
D Opening comment programming
q Push [F] to enter the function
mode, and then push [Y]/[Z] to
select the ATIS code program-
ming function.
• "ATIS ID" appears.
w Push [H/L•KEY] to edit the ATIS
code.
• "Id" and "ATIS" appear, and the 1st
character of the code blinks.
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
23