Connecting The Antennas; Installation Requirements - SMC Networks EliteConnect SMCWHSG14-G User Manual

2. Mount the device in the rack, using three rack-mountings screws.
Note: If the screws are not properly anchored, the strain of the cables connected to the Wireless
Hotspot Gateway rear panel connectors could pull out the Wireless Hotspot Gateway from the
wall.

2-2 Connecting the Antennas

The Wireless Hotspot Gateway provides two antenna connectors on the rear of the unit.

2-3 Installation Requirements

Before installing the Wireless Hotspot Gateway, make sure your network meets the following
requirements.
System Requirements
The Wireless Hotspot Gateway requires one of the following types of software:
Windows 98 Second Edition/NT/2000/XP
Red Hat Linux 7.3 or later version
MAC OS X 10.2.4 or later version
Any TCP/IP-enabled systems like Mac OS and UNIX (TCP/IP protocol installed)
Standard phone line for xDSL modem
Or
Coaxial cable for Cable modem
Web Browser Software (Microsoft I.E 5.0 or later version or Netscape Navigator 5.0 or later
version)
One computer with an installed 10Mbps, 100Mbps or 10/100Mbps Ethernet card
UTP network Cable with a RJ-45 connection (Package contents)
Note: Prepare twisted-pair cables with RJ-45 plugs. Use Cat.5 cable for all connections. Make sure
each cable not exceed 328 feet (Approximately 100 meters).
SMCWHSG14-G
17