Constant Current Source Mode Procedure; Figure 5-1: Current Loop Test Connections - Honeywell SmartLine SLG 700 User Manual

Constant Current Source Mode Procedure

1. Refer to Figure 5-1
output current loop.
2. Establish communication with the Transmitter. For these procedures, the values of components in
the current loop are not critical if they support reliable communication between the Transmitter
and the Toolkit.
3. On the Toolkit, display the Output Calibration box.
4. In the Output Calibration box, select the Loop Test button; the LOOP TEST box will be
displayed.
5. Select the desired constant-level Output: 0%, 100%, or Other (any between 0% - 100%).
Page 130

Figure 5-1: Current Loop Test Connections

for test connections. Verify the integrity of electrical components in the
SLG 700 SmartLine Level Transmitter User's Manual
Revision 8