Options - Olivetti ECR 7700LD eco Plus SD User Manual

Percent Discount (-%) or Add On (+%)
PRG
[numbers]
1 = Percent discount
Example:
Type/Press:
You can program up to four different foreign currency
exchange rates. The foreign currency value is displayed
whenever is pressed during a sales transaction.
1. Control key position: PRG.
2. Type the identification number
corresponding to the foreign currency exchange rate
that you wish to define and then press
3. Type the [decimal point position] of the exchange rate
(0-8 digits after the decimal point).
4. Type the [decimal point position] of the converted
amount (0-3 digits after the decimal point).
5. Type the [exchange rate] using up to six digits without
specifying any decimal point.
6. Press .
Example: Program the first exchange rate as:
1 GBP = 1.172 EURO.
Type/Press:
Dec. point position of
Exchange rate
exchange rate
ID number
Exchange rate (1.172 Euro)
When the Foreign currency conversion calculation sys-

options

tem option 15 is set to Divide, the converted amount is
calculated as follows:
Conversion Amount = Subt FC rate
When the Foreign currency conversion calculation is set
to Multiply, the converted amount is calculated as
follows:
Conversion Amount = Subt x FC rate.
You can define a currency descriptor of up to 10 characters
long for each of the four exchange rates programmed. The
descriptor of the foreign currency used will be printed on
the customer receipt during sales transactions that are
finalized with payment in foreign currency, and on the
management reports.
1. Control key position: PRG.
2. Press
3. Press
4. Enter the descriptor to assign to the selected foreign
5. Repeat steps 3 and 4 if you wish to assign a descriptor
6. Press
Example: Name foreign currency 1 "EURO" by using the
alphanumeric keypad.
to
.
Type/Press:
Dec. point position of
converted amount
until displaying the message "FC1"
indicating the first of the four possible foreign currency
exchange rates.
repeatedly until displaying the desired
exchange rate identification number on the left-hand
side of the operator display.
currency and then press
to the remaining foreign currencies, if defined.
to exit.
Switch to foreign currency
definition mode
Confirm entered
foreign currency
descriptor
.
Exit
11