Changing A Field's Setting - HP 8924C User Manual

Chapter 1, Getting Started

Changing A Field's Setting

Units-of-Measure Field
Figure 2 Units-of-Measure Field
26
Changing A Field's Setting
There are several types of CRT display fields in the Test Set. This section
describes some of the different types of fields, and how they are used.
Units-of-measure fields allow selection of valid units for given measurement. See
in to see an example of a units-of-measure field.
figure 2
To change a unit-of-measure
1. Position the cursor at the unit field on the display.
2. Press a key labeled with a different unit-of-measure (such as W).
3. If the new units are valid, the measurement value will be displayed in the new unit-of-
measure.
To change the units-of-measure for data transfer via HP-IB, see
of-Measure for HP-IB Data Transfer" in chapter 3
"To Specify Units-
.
S:\HP8924C\USRGUIDE\BOOK\chapters\getstart.fb