Table of Contents
Advertisement
Installation
3. Please remove the cover of the auto iris lens connection plug and solder the
lens cable to the connector pin in the plug.
Pin No.
DC
No.1 Pin
Damping-
No.2 Pin
Damping+
No.3 Pin
Drive+
No.4 Pin
Drive-
No.3 Pin
No.1 Pin
No.4 Pin
No.2 Pin
4. Please replace the auto iris lens connection plug cover and take off the CCD
protection cap, and then attach the auto iris lens to the camera by screwing
it in clockwise.
5. Please insert the connection plug that is
connected to the auto iris lens cable into the
auto lens connector, which is located on the
side of the camera.
6. Please set the lens selection switch, located on the
side of the camera, to DC or VIDEO depending on the
type of auto iris lens which is being used.
16
COLOR CCD CAMERA
LENS
VEDIO
Red (power)
NC
White (video signal)
Black (GND)
Lens cable
Connector
User's Manual
When using a C-Mount lens
Please take off the CCD protection cap and
attach the C-Mount lens to the camera by
screwing it in clockwise.
C-mount adaptor
When using a CS-Mount lens
1. Please take off the CCD protection cap and
C-mount adaptor.
C-mount adaptor
CCD protection cap
2. Please attach the CS-Mount lens to the
camera by screwing it in clockwise.
C-mount adaptor
Notes
• Please use the specified lens connection parts as shown in the picture below.
The use of the wrong sized parts of the wrong size may cause
damage to the inside of the camera or result in poor fitting.
• Use of a lens which is too heavy affects the balance of the
camera and may cause a malfunction. Please use a lens
that weighs less than 450g.
• Please select Av mode if possible when adjusting the
automatic light control (ALC) of an auto lens. Use of PK
mode may cause hunting.
COLOR CCD CAMERA
C-mount lens : 10 mm or less
CS-mount lens : 5 mm or less
17
User's Manual
Advertisement
Table of Contents
