Table of Contents
Advertisement
Camera Operation
SHUTTER (condition and speed control)
1. When the SETUP menu is on the screen, please position the arrow to point
to 'SHUTTER' by using the DOWN button.
2. Please select the shutter mode by pressing the LEFT or RIGHT button.
FLK: Please select 'FLK' mode when flickering occurs on the screen, due to an
imbalance between illumination and frequency. NTSC Model:1/100, PAL
MODEL: 1/120
ESC: Auto control of the shutter speed can be achieved. When ESC mode is on, the
speed is controlled automatically according to the brightness of the screen.
MANUAL: The shutter speed can be controlled manually.
SETUP
LENS
SHUTTER
WHITE BAL.
BACKLIGHT
AGC
3. Please select 'MANUAL' mode if you wish to adjust the shutter manually.
• You can select speed from '1/60' to '1/120,000'sec (NTSC Models), '1/50'
to '1/120,000'sec (PAL Models).
4. Please press the SETUP button when all the settings are complete.
Notes
• When selecting DC/VIDEO lens, the shutter speed is fixed at 1/60 (1/50).
• While using the internal synchronous system, if the shutter setting is on
'ESC' and the camera is directly facing a bright fluorescent light, the image on
the screen can be adversely affected. Therefore please choose the installation
location with care.
• When 'MANUAL' mode is on, the SENS UP function does not operate.
24
COLOR CCD CAMERA
MANUAL
ESC
ATW
OFF
MIDDLE
User's Manual
WHITE BALANCE control
The screen color can be adjusted by using the WHITE BALANCE function.
1. Please position the arrow to point to 'WHITE BAL' on the SETUP menu by
using the UP and DOWN buttons.
2. Please select the mode you wish to operate by pressing the LEFT or RIGHT button.
SETUP
LENS
SHUTTER
WHITE BAL.
*Please select one of the 3 modes below.
ATW(Auto Tracking White Balance):
• NORMAL : This mode can be used within the color temperature range 1,800˚K~
8000˚K . (fluorescent light, outdoor, normal environment)
• SPECIAL : This mode can be used within the color temperature range 1,800˚K~
10500˚K (strong sodium vapor lamp or metal lamp)
AWC(Auto White Balance Control): Please press the SETUP button while the
camera is directed at a piece of white paper to obtain the optimum state under
current illumination. If the environment including the light source is changed, you
have to adjust the white balance again.
MANUAL : The manual adjustment mode enables finer adjustment. Please select
ATW or AWC first. Please change to manual adjustment mode and press the SETUP
button. Please set the appropriate color temperature, and then increase or decrease
the red and blue color values while monitoring the color changes on the object.
Notes
•Under the following conditions the WHITE BALANCE function may not operate
properly. In such cases, please select the AWC mode.
When the object's surroundings have a very high color temperature (Ex. a clear sky and sunset)
When the object's surroundings are dark
If the camera directly faces a fluorescent light or is installed in a place where there are
considerable changes in illumination, the WHITE BALANCE function may become unstable.
COLOR CCD CAMERA
DC
- - -
ATW
25
User's Manual
Advertisement
Table of Contents
