Setting A Dynamic Route - Zte ZXV10 W615 User Manual

ZXV10 W615 User Manual
2. Configure the parameters. Refer to the following table.
Parameter
WAN
Connection
Prefix
Gateway
Modify
Delete
—END OF STEPS—

Setting a Dynamic Route

This section describes how to set a dynamic route.
Steps
1. Select Network > Routing > Dynamic Routing. The following page is
displayed.
46 Confidential and Proprietary Information of ZTE CORPORATION
Description
Select the related interface as needed.
Fill in the front blank with the IPv6 address.
Fill in the back blank with the length of the subnetwork prefix.
The Gateway IP address (Next hop)
Click to edit the corresponding static route rule.
Click to delete the corresponding static route rule.