Regulatory Information - DSC LE4000 Installation Manual

REGULATORY INFORMATION

MODIFICATION STATEMENT
Digital Security Controls has not approved any changes or
modifications to this device by the user. Any changes or
modifications could void the user's authority to operate the
equipment.
Digital Security Controls n'approuve aucune modification
apportée à l'appareil par l'utilisateur, quelle qu'en soit la
nature. Tout changement ou modification peuvent annuler le
droit d'utilisation de l'appareil par l'utilisateur.
INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause unde-sired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radio
électrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
WIRELESS NOTICE
This equipment complies with FCC and IC radiation
exposure limits set forth for an uncontrolled environment.
The antenna should be installed and operated with minimum
distance of 20 cm between the radiator and your body.
Cet appareil est conforme aux limites d'exposition aux
rayonnements de la IC pour un environnement non contrôlé.
L'antenne doit être installé de façon à garder une distance
minimale de 20 centimètres entre la source de rayonnements
et votre corps.
Antenna gain must be below/Gain de l'antenne doit être ci-
dessous:
Frequency Band/Bande
de fréquence
GSM850 / FDD V
PCS1900 / FDD II
LTEB2
LTEB4
LTEB5/B12/B13
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
L'émetteur ne doit pas être colocalisé ni fonctionner
conjointement avec à autre antenne ou autre émetteur.
LE2077
2.10 dBi
1.90 dBi
1.90 dBi
1.60 dBi
2.1/ - 1.8/0 dBi
FCC CLASS B DIGITAL DEVICE NOTICE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAN ICES-3 (B)/ NMB-3 (B)
FCC ID: F5318LE2077
IC:160A-LE2077
FCC/IC LABEL
This modular transmitter is labeled with its own FCC ID
and IC number. When the module is installed inside the
host device and the FCC ID/IC of the module is not
visible, the host device shall display the provided label
referring to the FCC ID and IC of the enclosed module.
This label is shipped together with the module and it is the
responsibility of the integrator to apply it to the exterior of
the enclosure as displayed in the following figure.
Le modulaire émetteur 3G7090 ou LT7090 est étiqueté
avec son propre ID FCC et le numéro IC. Lorsque le
module est installé à l'intérieur du dispositif hôte WS900-
19 ou WS900-29 et la FCC ID / IC du module ne soit pas
visible, le dispositif d'accueil affiche l'étiquette fournie se
référant à l'ID FCC et IC du module ci-joint. Ce label est
livré avec le
module et il est de la responsabilité de l'intégrateur de
l'appliquer à l'extérieur de l'enceinte, comme indiqué dans
la figure suivante.
Model LE2077
Contains FCC ID: F5318LE2077
Contains IC: 160A-LE2077
31
FCC/IC label
Approval label