Operator's Display Replacement; When Fixing Parts That Use Vesa Mounts Are Not Installed - Panasonic JS-970 Series Operating Instructions Manual

Operator's Display Replacement

Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is "OFF" before the operation below.

■ When fixing parts that use VESA mounts are not installed

1
Follow step 1 in "AC Adapter Installation" to remove
the cable cover. (
2
Loosen two thumbscrews securing the main block
and the operator's display.
● Loosen the thumbscrews until they are extended
by their springs.
● If you continue to loosen the thumbscrews further
after they are extended, they could become
detached. Make sure not to detach them.
3
Hold both sides of the display unit and slowly
separate the main block from the operator's display.
page 28)
Thumbscrews
37