Cable Wire Routing In Stand Unit - Panasonic JS-970 Series Operating Instructions Manual

5
Follow step 8 in "Display Unit (Including Main Block)
■
Replacement /
mounts are installed" to install the cable cover.
( page 36)

■ Cable wire routing in stand unit

1
Follow steps 1 through 2 in "AC Cord Kit Installation"
to remove the base cable cover. (
2
Pass the cables connected in "
in display unit" (
clamps to secure them to the stand unit.
To prevent the cables from interfering with your work
to secure the base cable cover, adjust the length of
each cable; route them in sequence from the center
of the cable clamps toward the outside so that they
do not overlap one another; and click the cable
clamp hooks into place to lock.
● To include extra length in the cables, adjust the
length of each cable with the display unit laid out
flat.
When fixing parts that use VESA
page 30)
■
Cable wire routing
page 44) through three cable
Cable clamp 1
Cable clamp 2
Cable clamp 2
Cable clamp 3
45