Display Unit Replacement; When Fixing Parts That Use Vesa Mounts Are Not Installed - Panasonic JS-960WP Series Operating Instructions Manual

Display Unit Replacement

Be sure to disconnect the power cable of the main block (POS Workstation) and
confirm the power is "OFF" before the operation below.

■ When fixing parts that use VESA mounts are not installed

(1) While pushing in the cable cover release button, slide the cable cover with both hands
to remove it.
p Perform the work on a flat surface.
p Place a non-slip mat on the surface to make the work easier.
(2) Open the screw covers (2 locations) of the main unit.
(3) Loosen the 2 thumbscrews securing the display unit.
p Loosen the thumbscrews until they are extended by their springs.
p If you continue to loosen the thumbscrews further after they are extended, they
could become detached. Make sure not to detach them.
(4) Hold the both sides of the display unit and pull out the unit slowly.
(1)-1 (1)
Cable cover
release button
(4)
22
(2) (3)