Equipment - Echo SHC-2620 Operator's Manual

SAFETY
Keep a Solid Stance
• Maintain footing and balance at all times. Do not stand
on slippery, uneven or unstable surfaces. Do not work
in odd positions or on ladders. Do not over reach.
Avoid Hot Surfaces
• Keep exhaust area clear of flammable debris.
Avoid contact during and immediately after
operation.
Never perform blade maintenance procedures while engine is
running.

Equipment

Use only ECHO attachments. Serious injury may result from the
use of a non-approved attachment combination. ECHO, INC. will
not be responsible for the failure of cutting devices,
attachments or accessories which have not been tested and
approved by ECHO, INC. Read and comply with all safety
instructions listed in this manual and safety manual.
Check unit for loose or missing nuts, bolts, and screws.
◆
Tighten and/or replace as needed.
Check that the cutting attachment is firmly attached and in
◆
safe operating condition. Dull, loose or damaged blades
should not be used.
Moving parts can amputate fingers or cause severe injuries.
Keep hands, clothing and loose objects away from all openings.
ALWAYS stop engine, disconnect spark plug, and make
◆
sure all moving parts have come to a complete stop before
removing obstructions, clearing debris, or servicing unit.
DO NOT start or operate unit unless all guards and
◆
protective covers are properly assembled to unit.
NEVER reach into any opening while the engine is running.
◆
Moving parts may not be visible through openings.
12
SHC-2620
X7502342002
© 03/2019 ECHO Inc.