Equipment - Echo DHCS-2800 Operator's Manual

DHCS-2800 / 3400
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause
harmful interference to radio or television reception. The reception
can be determined by turning the equipment off and on. The user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Equipment

Use only approved attachments. Serious injury may result from
the use of a non-approved attachment combination. ECHO
Incorporated will not be responsible for the failure of cutting
devices, attachments or accessories which have not been
tested and approved by ECHO Incorporated. Read and comply
with all safety instructions.
Check unit for loose or missing nuts, bolts, and screws.
◆
Tighten and/or replace as needed.
Check that the cutting attachment is firmly attached and in
◆
safe operating condition. Dull, loose or damaged blades
should not be used.
X7508280300
© 08/23 ECHO Incorporated
SAFETY
13