Operation - Ryobi RIG2000PCB Original Instructions Manual

Digital inverter generator
Table of Contents

Advertisement

appliances are connected to the product, the engine will
idle. If an appliance is added, the engine speed will increase
to power the appliance. If the appliance is removed, the
engine will return to idle.
CARRY HANDLES
The generator is equipped with two carry handles for
easy transport. Both handles should be used to carry the
generator.
ENGINE CHOKE/OFF SELECTOR KNOB
The engine choke/off selector knob is used when starting,
stopping, and running the engine.
FUEL TANK
The fuel tank has a capacity of 4.5 L.
GROUND TERMINAL
The ground terminal is used to assist in properly grounding
the generator to help protect against electric shock. Consult
with a local electrician for grounding requirements in your
area.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add oil to the generator
when necessary.
PARALLEL KIT TERMINALS
The non-polarized parallel kit terminals are used with a
parallel kit (sold separately) that will allow generators to be
linked together to increase output.
NOTE: Read and understand the parallel kit's instructions
prior to use. The kit is for use with the RIG2000PCB only.
RESET BUTTON
The reset button is used to restore power if an overload
occurs. To restore power, remove all attached load and
depress the reset button.
LED DISPLAY
LEDs provide feedback to indicate whether the generator is
in use, overloaded, or in need of lubricant.
RETRACTABLE HANDLE
The generator is equipped with a retractable handle that
can be adjusted for storage and transportation.
USB OUTLETS
The two 5 Volt, 2.1 Amp max USB charging outlets will
charge most USB-compatible devices.
STARTER GRIP AND ROPE
The starter grip and rope is used (along with the engine
choke/off selector knob) to start the generator's engine.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of
lubricant in the crankcase is insufficient.
Original instructions
ASSEMBLY
UNPACKING
The product has been shipped completely assembled.
Remove one end of the box and carefully slide out the
generator and any accessories.
NOTE: The generator is heavy. If you must lift the
product out of the box, get another person to help you;
lift with your legs, not your back.
Inspect the product carefully to make sure no damage
occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, take the product to
an authorised service centre.
PACKING LIST
Generator
Engine lubricant (SAE 10W 30) (355 ml)
Paper funnel
Spark plug wrench
Operator's manual
WARNING
If any parts are damaged or missing, do not operate the
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any such alteration or modification is considered as
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

WARNING
Carbon Monoxide. Using a generator indoors can
cause death in minutes.
Generator exhaust fumes contains high levels of carbon
monoxide (CO), a poisonous gas you cannot see or smell. If
you can smell the generator exhaust fumes, you are breathing
CO. But even if you cannot smell the exhaust fumes, you
could be breathing CO.
Never use a generator inside homes, garages,
crawlspaces, or other partly enclosed areas. Deadly
levels of carbon monoxide can build up in these areas.
Using a fan or opening windows and doors does not
supply enough fresh air.
Only use a generator outdoors and far away from open
windows, doors, and vents. These openings can pull in
generator exhaust fumes.
| English
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents