Craftsman 580.328300 Owner's Manual page 5

WHEEL KIT INSTALLATION
To install your wheel kit, you will need the following
tools:
• 13mm metric box, open end or socket wrench
Install Wheel Kit as follows:
1. Place the bottom of the generator cradle on a flat,
even surface. Place temporary blocks under the
cradle to ease assembly.
2. Slide axle through both axle mounting brackets on
cradle frame.
3. Slide spacer over each end of axle.
4. Install the wheel. Secure wheel on axle with
retaining pin and washer.
Axle
Handle
Weld
Nut
Spacer
Washer
Wheel
NOTE: Be sure to install the wheel with the air
pressure valve outboard.
5. Install other wheel in the same manner.
6. Secure the vibration mount on the support leg with
lock nut, washer, and 30mm long capscrew.
7. Fasten the support leg to the bottom of the
generator cradle using two 20 mm capscrews, two
lock washers and two flat washers. Remove
temporary blocks.
8. Position the handle below the muffler bracket on
the frame, as shown. Attach the handle with four
45mm long capscrews and four lock nuts.
9. Recheck all nuts to make sure they are tight and
secure.
Locking
Nut
Locking
Nut
Vibration
Mount
Retaining
Pin
5
45mm
Capscrew
Support
Leg
Flat Washer
Lock Washer
M8 Flat
Washer
20mm
30mm
Capscrew
Capscrew