Grundig WTR 3000 BT Manual page 8

SETTINGS
Tuning­and­storing­radio­stations­
(FM)­–­first­installation
When the device is switched on for the first time
or after factory reset, the Auto Tuning System will
start to.
Scan the FM waveband and store the first 10 ra-
dio stations as presets 1 to 10.
The time is updated automatically.
1
For the best FM reception, it is sufficient to
extend the telescopic antenna and direct it ac-
cordingly.
2 Press »ON/OFF« to switch on the device.
– The automatic station search starts, searches
and stores the radio stations.
– Displays
radio stations are stored at the presets.
Tuning­and­storing­FM­radio­sta-
tions­–­after­a­removal
You can activate the Auto Tuning System again.
That is reasonable, if you will use the device in
another place or search new radio stations.
1 Press »ON/OFF« to switch on the device.
– Display: the frequency of a FM radio station.
2 Open the menu with »Menu«.
3
Select the option »ATS« with »
firm by pressing »OK/i«.
– It starts the automatic station search.
– The automatic station search starts, searches
and stores the radio stations.
8­ ­ ENGLISH
­ - --------------------------------------------------------------------------------------------------------------------------------------
that 10
­
« and con-
r e
Programming­FM­radio­stations­–­
manually
1
Select the input source FM with »Mode/AL«.
2
Open the menu with »Menu«.
3 Confirm the option »Scan« by pressing
»OK/i«.
– Display: »Scan All«.
Note:­
You can select whether the device will scan
7
radio stations with weak signal (display
»Stron g «) or all radio stations (display:
»All«).
4
Select the desired option with »
firm by pressing »OK/i«.
FM
5 Press »Menu« to switching off the menu
6
Press and hold down »
desired radio station.
– The automatic station search starts, and stops
at the next station with a strong signal;
or
press briefly »
frequency you want.
– The frequency changes in steps of 50 kHz.
7
To store the FM radio station on a preset, press
and hold down the required preset button »1«
to »5«, until »P1« appears.
Note:­
Press the »5+­­
7
appears and flash, press »1« to »5« for pre-
sets 6 to 10.
­
r e
« or » « to search the
r e
« or » « until you have found the
r e
e II«symbol button until »P«
« and con-