Vertical Service Activation Codes Section - Cisco WRP500 Administration Manual

Regional page
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
Interdigit Short Timer Short timeout between entering digits when dialing. The
Ccomputer Delay
Ccomputer Duration
Voice tab > Regional page >

Vertical Service Activation Codes section

Vertical Service Activation Codes are automatically appended to the dial-plan. There is no need to
include them in dial-plan, although no harm is done if they are included.
Call Return Code
Call Redial Code
Cisco WRP500 Administration Guide
A-20
Interdigit_Short_Timer is used after any one digit, if at least one
matching sequence is complete as dialed, but more dialed digits
would match other as yet incomplete sequences. Range: 0–64
seconds.
The default is 3.
Delay in seconds after caller hangs up when the WRP500 starts
removing the tip-and-ring voltage to the attached equipment of the
called party. Range: 0–255 seconds. This feature is generally used
for answer supervision on the caller side to signal to the attached
equipment when the call has been connected (remote end has
answered) or disconnected (remote end has hung up). This feature
should be disabled for the called party (in other words, by using the
same polarity for connected and idle state) and the Ccomputer
feature should be used instead.
Without Ccomputer enabled, reorder tone will is played after a
configurable delay. If Ccomputer is enabled, dial tone will be
played when tip-to-ring voltage is restored Resolution is 1 second.
The default is 2.
Duration in seconds for which the tip-to-ring voltage is removed
after the caller hangs up. After that, tip-to-ring voltage is restored
and dial tone applies if the attached equipment is still off-hook.
Ccomputer is disabled if this value is set to 0. Range: 0 to 1.000
second. Resolution is 0.001 second.
The default is 0 (Ccomputer disabled).
This code calls the last caller.
The default is *69.
Redials the last number called. .
The default is *07.
Appendix A Advanced Voice Fields