Extra Rinse; Supersoak; Delay End; Check Water Error - Whirlpool LSA 1300 Service Manual

CONTROL COMPONENTS AND SPECIFICATION
RID#1 .5 EXTRA RINSE
1) Extra Rinse selection will be Extra Rinse selection will be improving the Rinseability performance whenever the
laundry requires
2) 2X/3X selection will result in 2
RID#1 .6 SUPERSOAK
1) Super soak option
in the Wash loads found to be higher
RID#1 .7 DELAY END
1) Delay End key is used to set the "Delay End" time for the selected wash program Delay End key is used to set the "Delay End" time for the selected wash program Delay End key is used to set the "Delay End" time for the selected wash program
RID#2 ERROR DISPLAY & ITS DIAGNOSIS ERROR DISPLAY & ITS DIAGNOSIS
RID#2.1 CHECK WATER ERROR

.1 CHECK WATER ERROR

1) If desired water level did not attain within 10 mins during fill then Check Water If desired water level did not attain within 10 mins during fill then Check Water If desired water level did not attain within 10 mins during fill then Check Water
Error will be popped by means of turning ON the Check water LED. Error will be popped by means of turning ON the Check water LED. Error will be popped by means of turning ON the Check water LED.
2) Inlet valve will move to OFF state after 5 mins from Check water error detection & Inlet valve will move to OFF state after 5 mins from Check water error detection & Inlet valve will move to OFF state after 5 mins from Check water error detection &
waits for start key press after checking the water inlet. waits for start key pres
3) Need to check:
a) Ensure the Water supply at the inlet.
b) Check for the blockage at fill hose and at the Inlet valve filter.
c) Ensure that Inlet valve is turning ON during fill process and if not check for
d) Check for pressure sensor frequency response & kink or puncture at the
e) Ensure that drain hose free end should be left in atmosphere not in any
f) Ensure that the Water head is >10ft from
RID#2.2 DRAIN ERROR
1) If the water in the If the water in the system fails to drain within 4 mins from the start of drain process
"dE" error will be popped with water level group LEDs blinking "dE" error will be popped with water level group LEDs blinking "dE" error will be popped with water level group LEDs blinking
2) Need to check:
a) Ensure that drain
AND SPECIFICATION
improving the Rinseability performance whenever the
selection will result in 2 / 3 Rinse Phases of a selected cycle
selection improves the Wash performance whenever the dirt level selection improves the Wash performance whenever the dirt level
found to be higher.
Ensure the Water supply at the inlet.
Check for the blockage at fill hose and at the Inlet valve filter. Check for the blockage at fill hose and at the Inlet valve filter.
Ensure that Inlet valve is turning ON during fill process and if not check for Ensure that Inlet valve is turning ON during fill process and if not check for
inlet valve operation & its connections from PCB to Inlet valve. inlet valve operation & its connections from PCB to Inlet valve.
Check for pressure sensor frequency response & kink or puncture at the Check for pressure sensor frequency response & kink or puncture at the
pressure hose. pressure hose.
Ensure that drain hose free end should be left in atmosphere not in any Ensure that drain hose free end should be left in atmosphere not in any
other medium. other medium.
Ensure that the Water head is >10ft from the Machine Inlet.
Ensure that drain hose should not be elevated for more than 20cms from the
ground level ground level
SERVICE MANUAL
cycle
the Machine Inlet.
mins from the start of drain process
ated for more than 20cms from the
Page | 26