Maintenance; Operation Mechanism - Panasonic S-60PE1R5B Operating Instructions Manual

Maintenance

WARNING
●
For safety, be sure to turn the air conditioner off and
disconnect the power before cleaning.
(Otherwise, electric shock or injury may result because
the fan is rotating at high speed.)
●
Do not pour water on the indoor unit.
(This may damage the internal components and cause an
electric shock hazard.)
CAUTION
●
Never use solvents or harsh chemicals. Also, do not wipe
plastic parts using very hot water.
(This may cause deformation or change in colour.)
●
Some metal edges and fi ns are sharp. Be careful when
you clean those parts.
(Injury may result.)
●
Use a fi rm stool or ladder when cleaning an indoor unit
installed in high locations.
●
The internal coil and other components of the outdoor unit
must be cleaned periodically.
• Consult your dealer or service center.
 Air Filter Maintenance (Field Supply)
Consult your dealer or service center when the
Timer Remote Controller
Filter Indicator
A
 Heating performance
●
Since the air conditioner utilizes outside air for heating,
its heating performance deteriorates as outside
temperature decreases.
(Due to heat pump system)
→ In that case, use another heating appliance.
 Defrosting
●
This appliance may start defrosting operation to melt
frost formed in the outdoor unit.
1 Defrosting starts: The indoor unit fan stops (or the
speed becomes extremely slow).
→ " "(STANDBY) appears.
2 Heating operation resumes after several minutes:
The indoor unit fan remains stopped (or it will run at a
very slow speed) until the indoor heat exchanger coil
warms up sufficiently.
→ " " (STANDBY) is shown.
3 Defrosting is complete: The indoor unit fan starts
operation.
→ " " (STANDBY) disappears.
PTW17_P07-T11600B (OI).indd 7 PTW17_P07-T11600B (OI).indd 7
Tips for Energy Saving
 Avoid
●
●
 Do
●
●
(Filter) appears on the display of the wired remote controller.
High-spec Wired
Remote Controller
Filter Indicator
20:30 (THU)

Operation Mechanism

 "DRY" operation
●
●
●
●
 Should the power failure occurs while the
unit is running
When the unit automatically resumes operation after
temporary power failure, it uses the same settings before
the power was cut off.
Do not block the air intake and outlet of the unit.
(If either is obstructed, the unit will not function
well, causing malfunction.)
During cooling operation, use sunshades, blinds or
curtains to prevent direct sunlight from entering the room.
Always keep the air fi lter clean.
(A clogged fi lter will impair the performance of the unit.)
→ "Maintenance"
To prevent conditioned air from escaping, keep
windows, doors and any other openings closed.
Once the room temperature reaches the level that was
set, the outdoor unit repeats the cycle of turning on and
off automatically.
When the outdoor unit is turned off, the indoor unit fan
will stop, too.
(To prevent the humidity in the room from rising again)
When the room temperature is more likely to reach the
level that was set, the fan speed is set to "breeze" (light
wind) automatically.
"DRY" operation is not possible if the outdoor
temperature is 15°C or less.
7
12/28/2017 2:09:11 PM 12/28/2017 2:09:11 PM