Axminster Bandsaw Original Instructions Manual page 11

Fence Assembly Support Bracket
The bracket helps to support the fence assembly when the
fence is in position up against the saw frame to utilise the
maximum width of the table (1)
Locate the fence assembly support bracket (19) and the two
M6 cap head screws (20). Line up the two pre-drilled holes in
the support bracket with tapped holes to the left side of the
cast iron table (1) and using the supplied Hex key secure the
bracket (19) in position, see fig 27-28-29.
Fig 27-28-29
19
Using the fence clamp assembly (4) as a level, tighten the two
cap head screws (20) to secure the bracket (19) in position.
Mitre Fence Assembly
Step 1 Locate the following parts (see page 3) Threaded lever
with washer (a), Grub screws (b), Hex keys (c), Mitre fence body
(d), Threaded 'T' bolts with clamping knobs (e), Aluminium fence
(f) and Depth stop (g).
Step 2 Screw the lever (a) through the elongated machined
cutout in the mitre fence body (d) and into the threaded hole in
the square steel bar. Lightly tighten, see fig 30.
20
Step 3 Introduce the 'T' bolts (e) through the two pre-drilled
holes in the mitre fence mounting bracket and screw on the
two clamping knobs, see fig 31. NOTE: Give adequate clearance
on the threads for the next step.
Hex key
Clamping knob
Step 4 Introduce the 'T' slot to the side of the fence (f) over
each threaded 'T' bolt (e) lightly tighten clamping knobs to
secure the fence (f) in position, see fig 32-33. NOTE: Make sure
the fence is in the correct way round, the base of the fence
should be flush with the cast iron table (1).
11
d
e
Main Assembly
Fig 30
a
Fig 31
e
Fig 32-33
f
Continues Over....