Limited Warr Ant Y - Cambridge Audio AXR85 User Manual

SERVICING
These units are not user serviceable, never attempt to repair, disassemble or
reconstruct the unit if there seems to be a problem. A serious electric shock could
result if this precautionary measure is ignored. In the event of a problem or failure,
please contact your dealer.
FEDERAL COMMUNICATIONS COMMISSION
Supplier's declaration of conformity (SDoC)
Equipment(s): Stereo Receiver
Model(s): AXR85,AXR100
Trademark: Cambridge Audio
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The responsible party in US:
Company name: Audio Partnership LLC
Address: 1913 N Milwaukee Ave. Chicago, IL 60647
Phone: (312) 636-4817
Legal Representative Person: Gregg Chopper
Signature:
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FEDERAL COMMUNICATIONS COMMISSION NOTICE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy, and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try and correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
RF EXPOSURE STATEMENT:
To maintain compliance with FCC's RF Exposure guidelines. This equipment should
be installed and operated with a minimum distance of 20cm between the radiator
and your body. Use only the supplied antenna.
MODIFICATIONS:
The FCC requires the user to be notified that any changes or modifications to this
device that are not expressly approved by Cambridge Audio, may void the user's
authority to operate the equipment.
CANADA-INDUSTRY CANADA (IC)
This radio transmitter has been approved by Industry Canada.
This device complies with Industry Canada's license-exempt RSSs.
Operation is subject to the following two conditions.
(1) this device may not cause interference and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device.
This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and your body.
The transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The device meets the exemption from the routine evaluation limits in section 2.5
of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian
information on RF exposure and compliance.
INDUSTRIE CANADA (IC)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le
radiateur et votre corps.
L'émetteur ne doit pas être co-placé ni fonctionner en conjonction avec une autre
antenne ou transmetteur.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section
2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir
l'information canadienne sur l'exposition et la conformité de rf.
EUROPE-EUROPEAN UNION NOTICE
Hereby, Audio Partnership PLC declares that this product is in compliance with
Directive 2014/53/EU, the full text of the EU declaration of conformity is available at
the following internet address:
https://www.cambridgeaudio.com/DoC
Bluetooth Radio Frequency:
2.402 GHz-2.48 GHz The Max. transmit power: 10dBm
PLUG FITTING INSTRUCTIONS (UK ONLY)
The cord supplied with this appliance is factory fitted with a UK mains plug fitted
with a 5 amp fuse inside. If it is necessary to change the fuse, it is important that
a 5 amp one is used. If the plug needs to be changed because it is not suitable for
your socket, or becomes damaged, it should be cut off and an appropriate plug fitted
following the wiring instructions below. The plug must then be disposed of safely,
as insertion into a mains socket is likely to cause an electrical hazard. Should it be
necessary to fit a 3-pin BS mains plug to the power cord the wires should be fitted as
shown in this diagram. The colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying the terminals in your
plug. Connect them as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter 'N' or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter 'L' or coloured RED.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter 'E' or coloured GREEN.
If a 13 amp (BS 1363) plug is used, a 5 amp fuse
must be fitted, or if any other type of plug is
used a 5 amp fuse must be fitted, either in the
plug or adaptor, or on the distribution board.