Special Note - Ryobi CSS1000 Owner's Operating Manual

Your CSS1000 mitre cutting and bevel cutting angles have been preset
at the factory but can and will be misaligned by rough handling and
transportation. It is essential that your new saw be realigned before use.
Please adhere to the following resetting instructions.
■ SQUARING THE BLADE TO
THE MITRE TABLE AT 0
Pull the saw arm all the way down and engage the
lock down pin to hold the saw arm in the transport
position.
Unlock the bevel lock lever and move the saw arm to
the 0 position and lock the bevel lock lever. (Fig 12)
Lay the set square on the mitre table and against the
blade and if the blade and mitre table do not align
adjust as follows. (Fig 13)
Fig 13
Unscrew the 0 0 bevel positioning bolt at the right
hand side as shown. (Fig 14)
0 Bevel Positioning Bolt
0

SPECIAL NOTE:

O
Fig 12
Fig 14
Page 7
Correctly align the blade and mitre table using the set
square and lock the bevel lock lever. (Fig 15)
Fig 15
Reset the 0 bevel positioning bolt so when the saw
0
arm is moved to the 0
bottoms out on the 0
and adjust the pointer to the 0
0
Positioning bolt
0 bevel position the bolt
0 bevel positioning bar (Fig 16)
0 position. (Fig 16A)
0 Bevel
Fig 16
Fig 16A