Manually Configuring Computer Network Settings - Belkin F5D8230-4 User Manual

Manually Configuring Network Settings
Set up the computer that is connected to the cable or DSL modem
FIRST using these steps. You can also use these steps to add
computers to your Router after the Router has been set up to connect
to the Internet.
Manually Configuring Computer Network Settings in Mac OS up
to 9.x
1.
Pull down the Apple menu. Select "Control Panels" and
select "TCP/IP".
2.
You will see the TCP/IP control panel. Select "Ethernet Built-In" or
"Ethernet" in the "Connect via:" drop-down menu
3.
Next to "Configure"
"Manually" is selected, your
Router will need to be set up
for a static IP connection type.
Write the address information in
the table below. You will need
to enter this information into
the Router.
4.
If not already set, at "Configure:", choose "Using DHCP Server".
This will tell the computer to obtain an IP address from the Router.
5.
If "Use the following IP address"
(2)
is selected, your Router will
need to be set up for a static IP
connection type. Write the address
information the table below. You
will need to enter this information
into the Router.
Restart the computer. When the computer restarts, your
network settings are now configured for use with the Router.
(1)
(2)
(2)
, if
77
(1)
.
1
2
3
4
5
6
7
8
9
10
11