“Protection” Flowchart - Philips 32PFL7403D/10 Service Manual

EN 32 5. Q528.2E LB
action holder: MIPS
action holder: St-by
autonomous action
Service Modes, Error Codes, and Fault Finding
MP
Log the appropriate error and
set stand-by flag in NVM
Redefine wake up reasons for protection
state and transfer to stand-by µP.
Switch off LCD lamp supply
Wait 250ms (min. = 200ms)
Switch off LVDS signal
Switch off 12V LCD supply within a time frame of
min. 0.5ms to max. 50ms after LVDS switch off.
Ask stand-by µP to enter protection state
Switch AVC in reset state
Wait 10ms
Switch the NVM reset line HIGH.
Disable all supply related protections and switch off
the +1V8 and the +3V3 DC/DC converter.
Wait 5ms
switch off the +1V2 DC/DC converter
Switch OFF all supplies by switching HIGH the
Standby I/O lines.
Flash the Protection-LED in order to indicate
protection state*
Protection
Figure 5-10 "Protection" flowchart
SP
(*): This can be the standby LED or the ON LED
depending on the availability in the set under
discussion.
I_17960_066.eps
220508