Offsetting Control Output ON Timing
4-2
Offsetting Control Output ON Timing
Disabled (No Offset)
ch1
ch2
ch3
ch4
Enabled (Offset)
ch1
ch2
ch3
ch4
Note
4-3
Turning OFF the Control Output
Note
The ON timing of control outputs for all of the channels can be adjusted to
reduce overlapping with each other. Set the Offset Control to perform this.
(Offset Control is enabled by default.)
In the following diagram, the ON timing overlaps between the channels.
In the following diagram, overlapping of the ON timing has been reduced.
Overlapping will vary with the control variables and changes to the control
variables.
Use the start/stop operation command to turn OFF control outputs. The start/
stop command can be used for all channels or for individual channels.
The start/stop status is written to nonvolatile memory. If the power is turned
OFF when a control output is stopped, it will still be stopped when power is
turned back ON. Use the Start/Stop operation command to enable operation
again.
Section 4-2
25